AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN | Impotent Questions | Question bank | Syllabus | Model and Previous Question papers | Download PDF

AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN | Impotent  Questions
AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Syllabus	Click Here to Download
AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Part A Important Questions	Click Here to Download
AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Part B Important Questions	Click Here to Download | Set-1 | Set-2 |  >>
AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Question Bank	Click Here to Download
AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Full Study Material	Click Here to Download
Other Subject Impotent Questions	Click Here to Download

OBJECTIVES: 
• The student will be able to understand the fundamental principles involved in design of
components of automotive chassis, the complete design exercise and arrive at important
dimensions of chassis components.

UNIT I    VEHICLE FRAME AND SUSPENSION 

Study of loads-moments and stresses on frame members. Design of frame for passenger and
commercial vehicle – Design of leaf Springs-Coil springs and torsion bar springs.

UNIT II     FRONT AXLE AND STEERING SYSTEMS 

Analysis of loads-moments and stresses at different sections of front axle. Determination of bearing
loads at Kingpin bearings. Wheel spindle bearings. Choice of Bearings. Determination of optimum
dimensions and proportions for steering linkages, ensuring minimum error in steering. Design of front axle beam.

UNIT III    CLUTCH 

Design of single plate clutch, multiplate clutch and cone clutch. Torque capacity of clutch. Design of
clutch components, Design details of roller and sprag type of clutches.

UNIT IV   GEAR BOX

Gear train calculations, layout of gearboxes. Calculation of bearing loads and selection of bearings.
Design of three speed and four speed gearboxes.

UNIT V    DRIVE LINE AND REAR AXLE 

Design of propeller shaft. Design details of final drive gearing. Design details of full floating, semifloating and three quarter floating rear shafts and rear axle housings and design aspects of final drive.

TOTAL : 45 PERIODS

OUTCOMES
• At the end of the course, the student can able to design the automotive components like
frame, suspension systems, axles, clutch, gear box, drive line components etc

TEXT BOOKS:
1. Giri, N.K., “Automobile Mechanics”, Khanna publishers, New Delhi, 2007.
2. Khurmi. R.S. & Gupta. J.K., “A textbook of Machine Design”, Eurasia Publishing House (Pvt)
Ltd, 2001.

REFERENCES:
1. Heldt, P.M., “Automotive Chassis”, Chilton Book Co., 1992.

2. Dean Averns, “Automobile Chassis Design”, Illife Book Co., 2001.

Also check :

AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Notes – Click here to Download 

AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN Questions Papers – Click here to Download 

AT6602 AUROMOTIVE CHASSIS COMPONENTS DESIGN 2 marks with answers – Click here to Download 

Check Anna University –  Exam Result | Internal Mark    >>

Check Anna University Syllabus All Department – Click Here to Download  >>  

Note : Questions posted in this page should be made use only as a reference material. These Questions may or may not appear in the Semester Examination. Kindly Refer our Questions for preparing for your exams and also share it with your friends.

Mail your study material to [email protected] We will mention your name here.